logo

Lithiumate™ Manual

index install

Installation

Installing and wiring a Lithiumate™ BMS

Four steps

You MUST provide a way for the BMS to shut down the source (charger), and the load, DIRECTLY!

Otherwise, your cells are NOT PROTECTED, and will not be balanced.

A cell board WILL be damaged if you do any of these common mistakes.

A DAMAGED CELL BOARD MAY DRAIN ITS CELL!

back to topCell boards

Small cylindrical cell Cell boards for small cylindrical cells
Single cell Cells in a column Cells in a column Cells side-by-side, full bank Cells side-by-side, split bank
Single cell Column, full bank Column, split bank Side-by-side, full bank Side-by-side, split bank

Large cylindrical cell
Cell boards for large cylindrical cells

Cylindrical cell
Cell boards for prismatic cells

Pouch cell
Cell boards for pouch cells

e-logo

© 2008~2024 Elithion™, LLC. All rights reserved, except where noted by CC mark. Page published on May 07 2024.
The Elithion brand and the 'ə' (upside down 'e') logo are Trademarks of Elithion LLC. Graphic design by morninglori

 

In this page: