logo

Lithiumate™ Manual

index plan system_wiring siemens

Siemens

Using a Siemens motor inverter with an Lithiumate BMS.

back to topSimovert 6SV
Function BMS Motor driver Connection BMS configuration Notes
Drive disable LLIM /pin 10 Emergency off / Notaus / Pin 2 Direct Set normally open, Limit grounded (default) REQUIRED
Regen disable HLIM /pin 11 Brake pedal wiper / Schleifer Bremsgeber / Pin 17 Place 1 kOhm resistor between pot wiper and pin 17 of motor driver; wire BMS directy to motor driver. Set normally open, Limit grounded (default) REQUIRED
End of charge step reduction FLT /pin 12 Power reduction / Leistungsreduzierung / Pin 20 Direct Set FLT out as a Warning out. Set normally open, warning grounded (default) Optional
End of charge gradual reduction DCL /pin 14 Accelerator pedal wiper / Schleifer Fahrgeber / Pin 34 Place 1 kOhm resistor between pot wiper and pin 34 of motor driver. Place diode, between BMS and motor driver, anode to motor driver. Set 5 V OK down to 0 V disable (default) Optional
back to topSimotion

Function BMS Motor driver Connection BMS configuration Notes
Drive disable LLIM /pin 10 Emergency off / Notaus / Pin 19 Direct Set normally open, Limit grounded (default) REQUIRED
Regen disable HLIM /pin 11 Regen disable / ??? / Pin 37 Direct Set normally open, Limit grounded (default) REQUIRED
End of charge step reduction FLT /pin 12 Power reduction / Leistungsreduzierung / Pin 36 Direct Set FLT out as a Warning out. Set normally open, warning grounded (default) Optional
End of charge gradual reduction DCL /pin 14 Accelerator pedal wiper / Schleifer Fahrgeber / Pin 7 Place 1 kOhm resistor between pot wiper and pin 7 of motor driver. Place diode, between BMS and motor driver, anode to motor driver. Set 5 V OK down to 0 V disable (default) Optional

e-logo

© 2008~2017 Elithion™, LLC. All rights reserved, except where noted by CC mark. Page published on Jul 19 2013.
The Elithion brand and the 'ə' (upside down 'e') logo are Trademarks of Elithion LLC. Graphic design by morninglori

 

In this page:By reading this page you acknowledge that you understand that these application notes are just suggestions, and that you will not hold Elithion responsible for their accuracy or appropriateness in you application, and that Elithion is not responsible for the fact that other manufacturers change their products in a way that may make these suggestions no longer applicable.